Replacement cartridge for Hydroplast B35 mixer taps
Advantages:
PAYMENTS:
Order also by phone
LUN - DOM 9 AM - 20 PM
Replacement cartridge for Hydroplast B35 mixer taps
HYDROPLAST original spare part
Features
Hydroplast B35 cartridge.
Brass rod for greater reliability,
picture 7x8
Maximum temperature limitation ring
Long Life silencer
Opening angle: 24 °
Mixing angle: 100 °
Installation tips
To ensure the best functioning and long life of the cartridge:
the seat of the tap: must be clean and free of incrustations, avoid grease, oil, paint and solvents
the hole in the tightening nut must be approximately 0.20 mm larger than the diameter of the cartridge collar
tightening: the ring nut must screw freely but without play and rest on the entire surface of the cartridge. Tighten with a torque of 1 ÷ 1.2 Kgm (10 ÷ 12 Nm) to avoid unnecessary overloads and ensure greater smoothness of operation
test: during tests without water, avoid repeated and improper activations. Avoid unnatural overloads on the lever even during packaging, transport and installation
installation: hot water temperature max 80 ° C, recommended 60-65 ° C. Supply pressure min. 0.1 bar, max 5 bar continuous, max 10 bar
occasional. Pressure difference between hot and cold water: recommended as low as possible (max 1.5 bar).
We recommend mounting filters on the water inlets.
Renato S. published the 01/06/2023 following an order made on 17/04/2023
good
Anonymous customer published the 27/09/2022 following an order made on 04/09/2022
Izdelek je OK!
Anonymous customer published the 09/03/2022 following an order made on 16/02/2022
Quello che serviva al rubinetto del mio camper
Anonymous customer published the 27/02/2022 following an order made on 13/02/2022
super 👍